The ID that the device is currently using to be managed by the Cambium Cloud Server.
When Enabled under Configuration->System, the device will be managed by the Cambium Remote Management System, which allows all Cambium devices to be managed from the Cambium Cloud Server. The current management status of the device with respect to the Cambium Cloud Server. The non-occupancy time for the radio frequencies in which radar was detected is 30 minutes.ĭisplays listing of FCC IDs applicable to the device.ĭisplays the number of active Read-Only users logged into the radio.ĭisplays the number of active Read-Write users logged into the radio.ĭisplays the mechanism used for authentication of web management interface users.Įnabled: When Enabled under Tools->Backup/Restore->Reset Via Power Sequence, it is possible to reset the radio’s configuration to factory defaults using the power cycle sequence.ĭisabled: When Disabled, it is not possible to factory default the radio’s configuration using the power cycle sequence.
System Not In Service due to DFS: The radio has detected a radar pulse and has failed channel availability checks on all alternative frequencies. In-Service Monitoring at Alternative Channel: The radio has detected a radar pulse and has moved operation to a frequency configured in DFS Alternative Frequency Carrier 1 or DFS Alternative Frequency Carrier 2. Radar Signal Detected: The receiver has detected a valid radar pulse and is carrying out detect-and-avoid mechanisms (moving to an alternate channel). In-Service Monitoring: Radio is transmitting and receiving normally while monitoring for radar pulses which require a channel move. If no radar pulses are detected, the device transitions to state In-Service Monitoring. N/A: DFS operation is not required for the region configured in parameter Country CodeĬhannel Availability Check: Prior to transmitting, the device must check the configured Frequency Carrier for radar pulses for 60 seconds). The hardware address of the device Ethernet interface. The hardware address of the device wireless interface. The total system uptime since the last device reset. This shows a factory-configured time until a valid NTP server is configured. The operating version of the device agent, which is used for communication with cnMaestro.Ĭurrent date and time, subject to time zone offsets introduced by the configuration of the device Time Zone parameter.
#Fcc id serial number download
This listing is also present on the GUI footer bar (which contains a hyperlink to download new system software).
#Fcc id serial number software
SM System Page Dashboard.png 1327×694 62.4 KBĬurrent operating version of software on the device.